How to setup universal repeater mode for FH303

Productline: wireless    question category:function config

Part 1: Loginthe homepage of the router

Part 2: Setup LAN IP

Part 3: Enableuniversal repeater mode

Part 4:Verify bridge connectivity

Part 5: Setup secondary SSID and security key


The Topology is asbelow:


Steps are asfollowing:

1. Login to themanagement page of the router.


2. Input loginusername and password as admin, to login, then click Advanced.

1. Click Network,and then click LAN. Change your router’s LAN IP.(The LANIP address should be different. For example, the uplink router hasthe LAN IP, then you can set the secondary router’s LAN IP as192.168.0.10)


1. Click Wirelessand then choose Wireless Extender, choose Universal Repeatermode. Click Open Scan.

2.Selectyour uplink router’s SSID, and input your uplink router’s security key. thenclick Save to save the settings.

1.Connectyour PC to this Tenda wireless router via a wired or wireless
connection and set it to "Obtain an IP address automatically". If youare not clear, see Appendix 1 Configure PC TCP/IP Settings .

2.Waituntil your PC successfully obtains an IP address.

3.ClickStart ->RUN;

4.Enter cmd and click OK.

5.Enter "ping default gateway IP address”. Here in this example, enter"ping" and press Enter. If you see a similar screen (highlightedarea), the bridge is established successfully.


Note: After finish the universalrepeater settings, the primary SSID will become secondary SSID automatically.

5.1 Click Wireless andWireless Basic Setting, change secondary SSID, and then click OK to save thesettings.

5.2 Setup the security key

Clickwireless security key, select SSID which you have set as secondary SSID, choosethe security mode as WPA-PSK, input your security key, andclick OK to save the setting.


NoticeIfyou have other PC need to be get connected, please connect it to the one of theLAN port or the wireless signal of the router. There is no need to configurethe router again.

12Very Good4854Article Views