Howto setup the Station mode?
Thereare five operation mode for this CPE. Auniversal repeater extends the wireless coverage of another wireless AP orrouter. The advantage of the universal repeater is that the remote device doesnot need to have WDS function and may not need to be the same brand. Therefore,it can work with almost any wireless device.
Part1:Connect the device
Part2: Set up the Universal Repeater mode
Connectone of the port to the router which can access internet, then connect your computerwith the other LAN ports of the router by a cable. Or you can connect itvia wifi.
Note:After connection the SYS light should be blinking, the WLAN light should be onor blinking.
1 A wirelessaccess point can’t provide the IP address for your computer.
You should setan IP address for your computer manually before login to the homepage ofthe AP. The default IP address of this AP is 192.168.0.254, so the IPaddress of your computer should be 192.168.0.XXX (1<=XXX<=253).
Open a browserthen type 192.168.0.254 in address bar, click Enter.
Note:if you cannot login the home page, please click HERE
2Fill in user name and password as admin/admin, and choose the country. click Login to login.
1choose Quick Setup—Universal Repeater, then click Next.
2open Scan and choose the uplink router’s SSID, click Next.
3Confirm the remote AP’s info and type in the security key of the remoterouter. Then click Next.
6. This page we canconfigure IP address of the AP. But we have to make sure the IP address isdifferent from remote AP’s address, but in the same network segment.
Such as if theremote router’s IP address is 192.168.0.1, we have to change this AP’s IPaddress to 192.168.0.2-253.
7 click save, you will see the AP reboot.
The“bridge” light will be on if you configure the AP successfully.
Useyour laptop or mobile phone to connect the wireless SSID, then type in thepassword to access the internet.