FAQ

Function configurationsHow to setup WISP mode for FH303

Productline: wireless    question category:function config

Part 1: Loginthe homepage of the router

Part 2: Setup connection type and LAN IP

Part 3: EnableWISP mode

Part 4: Setupsecondary SSID and security key

 

The Topology is asbelow:

 

Steps are asfollowing:

1. Login to themanagement page of the router.

192167.jpg

2. Input loginusername and password as admin, to login, then click Advanced.

 

 

             

1.ClickAdvanced, then click Internet connection setup. Choose DHCP, click Save.

2. Click Advanced,and then click LAN Settings. Change your router’s LAN IP.(The LANIP address should be in different network segment.For example, the uplink router has the LAN IP 192.168.0.1, then you can set thesecondary router’s LAN IP as 192.168.10.1.)

1. Click Wireless and then choose Wireless Extender, choose WISP mode. Click Open Scan.

.

2.Selectyour uplink router’s SSID, and input your uplink router’s security key. thenclick Save to save the settings.

3.After reboot, ifthe connection status shows connected and get the gateway of uplink router, itmeans that you can have internet.

 

Note: After finish theWISP settings, the primary SSID will become secondary SSID automatically.

4.1 Click Wireless andWireless Basic Setting, change secondary SSID, and then click OK to save thesettings.

4.2 Setup the security key

Clickwireless security key, select SSID which you have set as secondary SSID, choosethe security mode as WPA-PSK, input your security key, andclick OK to save the setting.

 

NoticeIfyou have other PC need to be get connected, please connect it to the one of theLAN port or the wireless signal of the router. There is no need to configurethe router again.

1Very Good579Article Views